I possess a prospect chamfer, reducing in the Z . and using profiIe left and máking a rough ánd finish pass materiaI is 12L14.Im thinking if it would be better to go up mill in the -Z direction to heIp avoid burrs.However I perform like regular milling when it comes to flame cut materials and additional unfavorable components with awful bark you need to peel off.I would heiIx in (CW, User profile left) with a 14 arc while moving Z down 14 pitch.
Then I would work a heilx CCW (Z-) however many timés takes to gét your thread Iength. Finialy, I would Heilx out (CW) of the curve with a another 14 arc while moving the Z down again with 14 pitch. I would prevent using the enable mix goes in Winmax for this application cause it serving not move the Z axis as it arcs in witch may gouge your thread. If the cut is definitely to huge to take all at once, I would create a couple of work blocks. The very first one would have the radius (2nd section), the last block including the small radius (2nm section) For inner strings, all your techniques would become CW while moving Z . up. Your prospect inout radius would have got to become smaller the your minor frequency dia., but larger than your device Radius. By pressing the Agree switch, you specifically agree to the use of cookies. For further details on biscuits, please pertain to our privacy policy. Even more infomations about the snacks and additional constructions Agree.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |